LORD® HPC-6C Coating Where To Buy
LORD® HPC-6C coating is a one-part, room temperature curing ethylene acrylic elastomer (AEM) coating which features robust adhesion and exceptional mechanical properties. This coating enhances ozone and fluid resistance on a wide variety of substrates while having very low VOCs.
Coating is composed of a mixture of polymers, organic compounds and fillers dissolved or dispersed in an organic solvent system. LORD HPC-6C coating is clear and colorable. Additionally, the LORD HPC-6C coating mixes well with colored pigments allowing for the creation of colored coatings.
Shelf life is one year from date of shipment when stored at 21-27°C (70-80°F) in original, unopened container. Do not store or use near heat, sparks or open flame.
Keep the container tightly capped when not in use to prevent solvent evaporation and moisture contamination.
Features and Benefits
Excellent Adhesion – provides strong adhesion to substrate and elongation of up to 600%; properly applied coating does not crack or peel. In laboratory testing, coating has demonstrated that it will not peel or crack prior to substrate cracking.
Ozone Resistant – provides ozone resistant barrier to external surface of elastomeric part, allowing bulk of component to be made of less expensive, less ozone resistant material. Resultant system offers low cost, high mechanical properties with high ozone resistance.
Fluid Resistant – provides fl uid resistant barrier to external surface of elastomeric part, allowing bulk of component to be made of less expensive, less fluid resistant material. Resultant system offers low cost, high mechanical properties with high fluid and environmental resistance. LORD HPC-6C coating provides resistance to sporadic and intermittent exposure to lubricating oils and transmission fluids, but is not designed for prolonged exposure. For long term fluid resistance against very aggressive fuels such as Jet A fuel, LORD HPC-3 coating should be evaluated.
Convenient – applies easily by spray, brush, dip or roll coat methods; can be easily incorporated into existing production lines. Coating cures at room temperature or with the aid of hot forced air.
Viscosity, cps @ 25°C (77°F)
Spindle 2, 30 rpm
|Density, kg/m3 (lb/gal)||1283.34 (10.71)|
|Solids Content by Weight, %||10.9|
|Solids Content by Volume, %||13.7|
Flash Point, °C (°F)
*Data is typical and not to be used for specification purposes.